Boreal peatland forests are an important source of timber. Recently, timber harvesting has been extended to warmer months, resulting in machinery traffic over unfrozen soils, and leading to higher levels of soil disturbance, such as deeper ruts. Despite this, our knowledge of the impact of soil disturbance on peat physical properties and soil biochemistry is still limited. To address this gap, I conducted a study to examine the effects of soil disturbance caused by harvesting machinery during thinning operations on the soil physical, chemical, and biological properties and vegetation of drained boreal peatland forests. To assess the rate of recovery, I sampled six sites that formed a chronosequence covering 15 years since thinning. The results showed that soil disturbance caused an increase in the bulk density and field capacity of peat, along with a decrease in total porosity. In the vegetation, moss biomass and root production were reduced, but sedge cover increased. Furthermore, recently disturbed areas exhibited greater soil CO2 production potential, as well as higher soil CO2 and CH4 concentrations compared to control areas. However, CO2 and CH4 emissions, microbial communities, and cellulose decomposition rate were not impacted. Although the rate of recovery varied, all studied properties impacted by disturbance were fully recovered within 15 years. As the water retention characteristic (WRC) describes soil structure and its alterations, it a useful for disturbance assessment. Thus, I propose how WRC can be predicted using artificial neural networks. Overall, the study demonstrated that while drained boreal peatlands are sensitive to disturbance, they are also resilient to mechanical soil disturbance caused by thinnings.
The aim of this work was to improve the protocol of somatic embryogenesis (SE) and propagation efficiency in Norway spruce (Picea abies (L.) Karst.), which would enable the integration of SE into Finnish breeding programme and the nursery practices applied to seedlings. The studies specifically investigated the following three areas: i) how maturation, cold storage, germination and growing conditions (laboratory–nursery interface) affect the survival and height growth of emblings (Papers I and II); ii) how to improve the efficiency of embling production from genotypes from wide genetic backgrounds (Papers I and II); and iii) how to increase propagation efficiency by rooting cuttings from emblings, and produce field testing material by combining SE and the rooting of cuttings (Papers II and III). To evaluate the possibility of improving the efficiency of SE in the laboratory–nursery interface, a series of experiments were conducted. The cost structure of SE, and the effects of improvements on costs, was estimated.
As a result, the protocol improvements doubled the yield of cotyledonary embryos, nearly doubled embling survival, and increased the height growth of emblings in the nursery by so much that sufficient planting height was reached one year less than before. Emblings were also obtained from 356 genotypes (50% thawed), and embling cuttings rooted well in conditions similar to those used for seedling cuttings. The protocol improvements also reduced embling production costs by 75%. Based on this work, emblings may be grown in nurseries after one week of in vitro germination, without any measures that differ from seedlings after transplanting. Propagation efficiency may be further increased by rooting embling cuttings. Furthermore, large-scale clone testing can be initiated with 5–12 emblings acting as cutting donors.